Home   |   About Us   |   Products   |   Services

Categories
 
  Complete Shinoda Kits
  1994-1998 Boss/Cobra Shinoda Mustangs
  1999-2004 Boss/Cobra Shinoda Mustangs
  2005-2009 Boss Shinoda Mustangs
  2010-2014 Boss Shinoda Mustangs
  2015 and up Mustang
  Shinoda Apperal
  Shinoda Collectables
  Team Shinoda Membership
  Team Shinoda 20 Years Celebration
 
New Products
 
 


2005-2009 Shinoda Performance Exhaust v6 Duel Agressive
Category->2005-2009 Boss Shinoda Mustangs->Exhaust
(TS-1111-05-6-A) 2005-2009 Shinoda Performance Exhaust v6 Duel  Agressive

Online Price

Price:

|

Qty:


Instructions: NOTE: DO NOT TIGHTEN ANY BOLTS OR CLAMPS UNTIL THE LAST STEP!!
 1) Support the vehiclein a safe manner, using a shop hoist or frame contact jackstands on a level surface.Remove the o.e. mufflers,at the clampswhere the oldmufflers bolt to the over the axlepipes.
2) Install the leftmuffler to the driver side over the axle pipe using a 2-1/2” clamp, line up the notch. Connect the wire hangers on the muffler to the o.e. mounts above.
3)Repeat step 2) for the right (passenger) side.
4) Check for clearance of the frame,body,suspension members,and of all brake and fuel lines. When you are satisfied with how themufflers hang, tightenthe clamps.
DANGER WARNING: Should the purchaser decide to install this exhaust product at home, be warned that pleasure car or light duty truck/van “bumper” jacks are intended for emergency use only. The use of frame contact jack stands in conjunction with a floor jack as main support is highly recommended to minimize accidental dropping of a vehicle while the installation proceeds.
 
 Limitation of liability--Disclaimers: The regulation of emissions production, noise levels and safety standards is undertaken by the federal government, each of the fifty state legislatures, and by many local municipalities, towns and counties. The manufacturer makes no warranties of merchantability, of fitness for a particular purpose, or that its products are approved for general use, or that its products comply with laws, regulations or ordinances in the states where they may be sold to the ultimate purchaser, the consumer. The entire risk as to the conformity of this product in any such state and as to repair, should the product prove to be defective or non-conforming, is on the retail purchaser, the buyer, the ultimate consumer of such product and it is not upon the seller, distributor, or manufacturer. In this connection, retail purchaser, the buyer, the ultimate consumer assumes the burden of the entire cost of any and all necessary service, alterations, and or repair. The foregoing statement limits the liability of the manufacturer.
 
 

Cart

 

 

Information

 
Home
Products List
Build Sheets
Check Out
Contact Us
Order Status
 

Viewed Products

 
Clear Viewed List Clear Viewed List
 


 

© Team Shinoda. All rights reserved. Home | About Us | Products | Services | Contact Us